Robo-Pony
Revision as of 13:46, 5 July 2015 by Notyou007a (talk | contribs)
[Equipment|Back to list of Equipment]]
Contents
General
|
Mapping
Moters
Color | Lable | Part | Bi-Derectional | Voltage |
---|---|---|---|---|
Purple | M3+ | Head Turn | Yes | 5V |
Brown | M3- | Head Turn | Yes | Ground |
Green | M4+ | Tail | No | 5V |
Yellow | M4- | Tail | No | Ground |
Blue | M5+ | Head nod | no | 5V |
Purple | M5- | Head nod | No | Ground |
Sensors
Label= Wiper3 Connecter color= Black
Pin | Wire color | Reads | Notes |
---|---|---|---|
1 | Blue | Head Turn angle | Common Ground |
2 | Gray | Head Turned Left | Switch is off when turned to the left |
3 | Gray | Head Turned Right | Switch is off when turned to the Right |
4 | Gray | Head Middle | Switches off when in the middle
over laps with left and right switch |
switches
Tail, Label=tailsw, two wire, Yellow Connecter, Closed? when tail in center down
Butt switch, Label=Rider, Two wire, Green Connecter, open?when down
Head Left and Right?, Label=Wiper 4, 4 wire, white connecter, One Blue + 3 Gray.
Input
MIC2(L) White 2 pin
MIC1(R) Black 2 pin
Output
SPK2 Purple
Don't know
CS 3,4,1 (Capacitive sensor?)
Gray = Front Left
Blue = Back Left
Red = Back Right
CS 2,5 (cap)
Yellow = Front Right
Red = Front Center