2019 Shapeoko 2 Refurbishment
Contents
- 1 General Information
- 1.1 Goal 1: Shapeoko 2 Device Refurbishment
- 1.2 Goal 1: Placement of Custom 3D Printed Parts
- 1.3 Goal 1: Rewiring
- 1.4 Goal 1: Completion
- 1.5 Goal 2: Controller System
- 1.6 Goal 2: Controller Description
- 1.7 Goal 2: Controller Box
- 1.8 Goal 2: Front Panel Build
- 1.9 Goal 2: Rear Panel Build
- 1.10 Goal 2: Electronics
- 2 General Photos
General Information
Goal 1: Shapeoko 2 Device Refurbishment
Goal 1: Placement of Custom 3D Printed Parts
Goal 1: Rewiring
Goal 1: Completion
Front
Right
Rear
Left
Goal 2: Controller System
Goal 2: Controller Description
Goal 2: Controller Box
Controller Box Assembled
Controller Box Disassembled
Goal 2: Front Panel Build
Goal 2: Rear Panel Build
Goal 2: Electronics
Three Boards - Arduino Uno, Arduino Prototyping Shield, CNC Shield V3.0
Notes: The Arduino has its power jack removed. The Arduino is powered thru the USB. The circuitry on the Prototyping Shield added noise filtering and debounce protection to the Limit Switch Lines and Control Buttons on the E-Stop pendant. The circuitry in the photo was modified according to the schematic below to improve debounce behavior.
The electronic were assembled in the stack below.
Controller Box 3D Printed Items
General Photos
E-Stop Pendant
E-Stop Pendant Power Cutoff Wiring
Power Box
Controller Box
Controller Panels
Electronics
GRBL Controller
General Layout
