2019 Shapeoko 2 Refurbishment

From LVL1
Jump to navigation Jump to search

General Information


General Shapeoko Refurbish 0.jpg


Goal 1: Shapeoko 2 Device Refurbishment

General Shapeoko Rebuild Elements.jpg

Goal 1: Placement of Custom 3D Printed Parts

General Shapeoko 3D Side View.jpg

General Shapeoko 3D Rear View.jpg

General Shapeoko 3D Z-Axis View.jpg


Goal 1: Rewiring

General Shapeoko Refurbish 1.jpg


General Shapeoko Device Cables.jpg

Goal 1: Completion

Front General Shapeoko Front View.jpg

Right General Shapeoko Right View.jpg

Rear General Shapeoko Rear View.jpg

Left General Shapeoko Left View.jpg

Goal 2: Controller System

General Shapeoko Refurbish 2A.jpg


Goal 2: Controller Description

General Shapeoko Refurbish 3.jpg


Goal 2: Controller Box

Controller Box Assembled

General Shapeoko Empty Controller Box 1.jpg

Controller Box Disassembled

General Shapeoko Empty Controller Box 2.jpg

Goal 2: Front Panel Build

General Shapeoko Front Panel Build X.jpg

Goal 2: Rear Panel Build

General Shapeoko Rear Panel Build.jpg


Goal 2: Electronics

Three Boards - Arduino Uno, Arduino Prototyping Shield, CNC Shield V3.0

General Shapeoko Electronics Boards.jpg

Notes: The Arduino has its power jack removed. The Arduino is powered thru the USB. The circuitry on the Prototyping Shield added noise filtering and debounce protection to the Limit Switch Lines and Control Buttons on the E-Stop pendant. The circuitry in the photo was modified according to the schematic below to improve debounce behavior.

General Shapeoko Switch Pin Filter.jpg

The electronic were assembled in the stack below.

General Shapeoko Electronics Stack.jpg


Goal 2: Controller Box Assembly

The electronic, wiring and cooling fans were organized and supported by custom 3D printed item.

General Shapeoko 3D CNTRLR View.jpg


General Shapeoko Refurbish 2.jpg


General Shapeoko Refurbish 3.jpg


General Shapeoko Refurbish 4.jpg

General Photos

E-Stop Pendant

E-Stop Pendant Isolated.jpg

E-Stop Pendant Power Cutoff Wiring


Shapeoko 2019 E-Stop Pendant Cutoff Wiring.jpg


Power Box

General Shapeoko Power Box.jpg


Controller Box

General Shapeoko Empty Controller Box 1.jpg


General Shapeoko Empty Controller Box 2.jpg


Controller Panels

General Shapeoko Front Panel Build X.jpg


General Shapeoko Rear Panel Build.jpg


Electronics

General Shapeoko Electronics Assembly.jpg

General Shapeoko Controller Guts.jpg


GRBL Controller

General Shapeoko GRBL Controller.jpg


General Layout

General Shapeoko Layout.jpg


General Shapeoko 3D CNTRLR View.jpg