Difference between revisions of "RPi based 3D Scanner"
| Line 58: | Line 58: | ||
Platform Bearing Top Ring qty. 1 (yellow) | Platform Bearing Top Ring qty. 1 (yellow) | ||
| + | |||
| + | == Rotating Platform Details == | ||
| + | |||
| + | [[File:RPI3D_Contruction_Platform_Assembled_View.jpg]] | ||
| + | |||
| + | [[File:RPI3D_Contruction_Platform_Exploded_View.jpg]] | ||
== Schematic == | == Schematic == | ||
Revision as of 13:24, 27 June 2019
The following scanner is based upon the FreeLss software and CiClops device design.
Website FREELSS
Website CiClop 3D Scanner
Contents
Basic Block Diagram
Structure
The scanning device is made from OpenBeam aluminum extrusion beams. The joining of the beams is via custom 3D printed parts and plates.
OpenBeam (violet)
30 cm length qty. 3
18 cm length qty. 2
12 cm length qty. 2
8 cm length qty. 6
3D Printed Joining Plates (red)
Tee Joining Plate qty. 6
El Joining Plates qty. 4
Blank Plate 7.5x4.5 cm qty. 1
Feet qty. 6
3D Printed Mounting Plates
Stepper Motor Plate qty. 1 (aqua)
PCB Plate 8x12cm qty. 1 (green)
Power Converter Plate qty. 1 (green)
RPi Case Plate qty. 1 (orange)
Camera Rear Plate qty. 1 (purple)
Camera Front Plate qty. 1 (white)
Laser Bracket Plate qty. 4 (blue and light blue)
Rotating Platform Saddle qty. 1 (yellow)
Platform Bearing Top Ring qty. 1 (yellow)
Rotating Platform Details
Schematic
Parts List
Raspberry Pi 3 B+ Raspberry 5.1 meg Camera Voltage Converter 12V => 5V Stepper Motor Mounting Hub (5mm)
DRV8825 Stepper Driver Module Laser Line Casting Module qty. 2
RPi Proto Breadboard PCB Ribbon Cable LED Strip 12V SPST Switch 16014 Open Bearing 70x110x13 Ball Bearings
