Difference between revisions of "Clive Badger"
Jump to navigation
Jump to search
(Created page with "{{Template:Equipment|owner=LVL1 owned |model=Makerbot Replicator |serial=? |arrived=June 1, 2012 |doesitwork=Working |contact=Chris C |where=3D printing area in main room}}<br...") |
|||
| Line 7: | Line 7: | ||
|where=3D printing area in main room}}<br> | |where=3D printing area in main room}}<br> | ||
__NOTOC__ | __NOTOC__ | ||
| + | |||
| + | ==ReplicatorG default settings== | ||
| + | * Slicing Profile: Replicator 2 Default | ||
| + | * Use Raft / Support (Check if you have overhangs or many pieces on a single build, otherwise uncheck) | ||
| + | * Use support Material (Exterior support if you have overhangs greater than 45 degree angles) | ||
| + | * Use default start / end gcode (Always check) | ||
| + | * Use Print-O-Matic (Always check) | ||
| + | ===Settings=== | ||
| + | * Object Infill (10%) | ||
| + | * Layer Height (.27) | ||
| + | * Number of Shells (1) | ||
| + | * Feedrate (41) | ||
| + | * Travel Feedrate (51) | ||
| + | * Print Temperature (220) | ||
Purchased for LVL1 from NSF funds for the UofL Speed School Co-op Makership | Purchased for LVL1 from NSF funds for the UofL Speed School Co-op Makership | ||
Revision as of 10:34, 10 December 2012
[Equipment|Back to list of Equipment]]
|
|
General
|
 |
ReplicatorG default settings
- Slicing Profile: Replicator 2 Default
- Use Raft / Support (Check if you have overhangs or many pieces on a single build, otherwise uncheck)
- Use support Material (Exterior support if you have overhangs greater than 45 degree angles)
- Use default start / end gcode (Always check)
- Use Print-O-Matic (Always check)
Settings
- Object Infill (10%)
- Layer Height (.27)
- Number of Shells (1)
- Feedrate (41)
- Travel Feedrate (51)
- Print Temperature (220)
Purchased for LVL1 from NSF funds for the UofL Speed School Co-op Makership
