Magic 8 of Hearts
Introduction
This write up is about a project merging the Magic 8-Ball with Valentine candies. The basic premise is that the heart is shaken like a Magic 8-Ball and message reminiscent of the candy heart sayings appear in the window.
The Magic 8 of Hearts, as we call it, has several features:
1. Inductively charged.
2. Shake to activate.
3. Digital LCD display of message.
Components
This project consists of the following parts.
| Arduino Nano | PowerBoost 500 Charger - Rechargeable 5V Lipo USB Boost @ 500mA+ |
| White LEDs | Inductive Charging Set - 5V @ 500mA max |
| 1.44" 128*128 TFT LCD SPI | 3.7v 650mah Li-po Battery |
| MMA7361LC 3-Axis Accelerometer ±1.5/6g | FQP30N06L MOSFET |
| Perf Board | Split Heart |
| Not Shown | |
| 49 ohms resister (LED) | 150 ohms resister (LCD Backlight) |
| Reed Switch | 12k ohms resister (MOSFET Limiter) |
Prepare The Heart
Make a hole in the heart.
Make a insertable Perf Board
Layout the Board
After several tries, the components are placed on the board.
Wiring of Boards
| Arduino Nano Pin | Accelerometer Pin |
| A1 | X-Axis |
| A2 | Y-Axis |
| A3 | Z-Axis |
| A4 | Free Fall 0g |
| 3.3v | Sensitivity |
| 3.3v | Vdd |
| GND | GND |
A reed switch (N.O.) connects Arduino Reset to GND.
| Arduino Nano Pin | 128*128 TFT LCD SPI Pin |
| D5 | LED Backlight w/ 150 ohm resistor |
| D8 | A0 |
| D9 | Reset |
| D10 | CS |
| D11 | SDA |
| D13 | SCK |
| 3.3v | Vdd |
| GND | GND |
| Adafruit Boost Charger Pin | Other Component Pin |
| USB | Vdd Adafruit Inductive Charger |
| BAT | V+ 3.7V LiPo Battery |
| 5V Arduino Nano 5V | |
| GND | Adafruit Inductive Charger |
| GND | GND Arduino Nano |
A reed switch (N.O.) connects Charger EN to GND.
Five white LEDs with a 49 ohm resistors in series are wired in parallel. The positive rail is attached to the 3.7v line of the LiPo battery. The GND rail is attached to the MOSFET Drain lead. The MOSFET Source lead is attached to Battery GND. A 12k ohm resistor is attached across the MOSFET Gate and Source leads. The Gate lead is also attached to the Arduino D6 pin.
Prepare the Screen
Classical wirewrap will connect the screen to the controller.
The screen is then glued into the front shell.
Solder up all the parts.
Power Plant
Place inductive charger receiver in back half of heart shell and glue in place.
Yes, I forgot to take a photo!
Place a rubber flap over unit to prevent shorts.
Arrange remaining power supply components.
Prepare another flap to insulate the power supply from the rest of the project.
Merge the Halves
