Screaming Bread

From LVL1
Jump to navigation Jump to search

The Idea

Louisville Mini Maker Faire was an opportunity for LVL1 and 1st Build have a little fun. So, LVL1 decided to play a prank. 1st Build had a refrigerator on display. The door would open and close during the event. When the door opens, the light goes on inside. So, what if when the door opened and the light went on inside, a loaf of bread screamed.

The Basics

A loaf of Bread

SBP Bread Loaf.jpg

AdaFruit FX Sound Board

SLB-FX Board.jpg

5v Power Supply

SBP Power Supply.jpg

CDS sensor

SBP CDS Sensor.jpg

Speaker

SBP Speaker.jpg

Recorded screams

Wiring

SBP Screaming Fritz.jpg

Power

A 5/3.3 volt power supply is located.

SBP Power Supply.jpg

The power supply will use a 9 volt battery. A barrel connector compatible with the power supply board is added to a 9v battery connector.

SBP Battery Pack.jpg

Light Trigger

First, we located a CDS cell. One was found in a motion detection sensor with a broken cover window.

SBP Motion Sensor 1.jpg

Breaking the cover window even more exposed the CDS cell.

SBP Motion Sensor 2.jpg

Next came removal and placement on a piece of PCB.

At first, it was thought that an external pull up resistor was needed to trigger the FX board. But the FX board had internal pull up resistors, so the added resistor was not necessary. Two wires were attached and the CDS sensor was ready.

SBP CDS Sensor.jpg SBP CDS Sensor Back.jpg

Putting It All Together

The assembly of the unit begins with connecting the power supply and FX Board. The pin alignment of the power supply and FX Board power terminals allows the two boards to be soldered together directly. Next the CDS Sensor is soldered to trigger line 1.

SBP Assembly 1.jpg SBP Assembly 2.jpg

Connect to power supply to the FX Sound Board. In this case, the power supply is set up to plug into a breadboard. So directly connecting the breadboard to FX board is straight forward.

The cell is wired to a pull up trigger pin on the FX board.

The idea is that when light hits the CDS, the resistance drops and the pin reads a ground signal. Speakers are wired next. Add recorded screams in a random setup and all is done for the circuit.

Bread

Next, a loaf of bread is hollowed out. The sensor is moved high in the loaf to detect light.

What Happened

The best laid plans did not work out. Access to the fridge was blocked. No joy.

Now What

Halloween is coming. Maybe another opportunity will arise.