Printed Parts
| 3D Printed Parts
|
| Parts
|
ID
|
Purpose
|
|
|
Control Panel Brackets
|
Fasten Control Panel to Main Device Sensor Layer
Brackets are not symmetrical and are tailored for the Main Device Sensor Layer hole placement
Screws shown with nuts provide offset positioning
|
|
|
Port Mounting Brackets
|
Secure RJ45 Ports to Arduino DUE base layer of Main Device
Brackets are not symmetrical and are tailored for the Arduino DUE hole placement
Velco added post printing
|
|
|
ATTiny85 Token Enclosure Box and Cover
|
Provides an enclosure for ATTiny85 Tokens
|
|
|
Corner Bracket Set
|
Provides corner bracketing for EEG External Unit
Threaded Inserts installed after printing
|
|
|
Respiratory Sensor Signal Amplifier Box and Cover
|
Provides enclosure of PCB
Access to adjustment potentiometer from cover
|
Assemblies With Printed Parts
Respiratory Sensor used with EKG External Unit
| 3D Printed Parts
|
|
|
|
- BLUE - Compression Sensor Orientation Stabilizer
- YELLOW - Compression Sensor Lower Bracket
- GREEN - Compression Sensor Top Bracket
- CYAN - Telescoping Tube Cradle
- RED - Rubber Band (Provides Flexing of Compression Sensor Brackets)
- VIOLET - Fastner (Holds Exterior Telescoping Tube Secure and Allows Inner Tube to Move)
- SEMI-TRANSPARENT GREEN - Outer Telescoping Tube (Inner Telescoping Tube visible)
|
Respiratory Sensor used with Poly-Liar External Unit
- YELLOW - Telescoping Tube Cradle
- GREEN - Sliding Plunger
- RED - Rubber Band (Provides Resistance and Recoil for Sliding Plunger against Telescoping Cradle)
- VIOLET - Reflectance Sensor PCB
- BLUE - Fastner (Secures Slinging Plunger to Inner Telescoping Tube)
- ORANGE - Inner Telescoping Tube
- SEMI-TRANSPARENT BLUE - Guide Tube for Sliding Plunger
- SEMI-TRANSPARENT GREEN - Outer Telescoping Tube
Pseudo-Medical Monitor Device Design
