Clive Badger

Back to list of Equipment

Equipment Overview

Owner/Loaner: LVL1 owned Serial Number: ? Make/Model: Makerbot Replicator Arrival Date: June 1, 2012 Usability: Working Contact: Chris C Where: 3D printing area in main room

ReplicatorG default settings

• Slicing Profile: Replicator 2 Default
• Use Raft / Support (Check if you have overhangs or many pieces on a single build, otherwise uncheck)
• Use support Material (Exterior support if you have overhangs greater than 45 degree angles)
• Use default start / end gcode (Always check)
• Use Print-O-Matic (Always check)

Settings

• Object Infill (10%)
• Layer Height (.27)
• Number of Shells (1)
• Feedrate (41)
• Travel Feedrate (51)
• Print Temperature (220)

Purchased for LVL1 from NSF funds for the UofL Speed School Co-op Makership