Group Project ELEPHANT 1.0

From LVL1
Jump to navigation Jump to search

GP LVL1 ELEPHANT PORTRAIT 1.jpg

Information

GP LVL1 ELEPHANT 1 0 WWW.JPG

Structure Parts List

Table Leg

Wooden Bowl

Broken Wooden Bowl

2 U-Bolts and nuts

Wooden Panel Board Scrap

Chain

Electronics Parts List

Raspberry PI B

4 Relay Module

NeoPixel Strip

PIR Motion Sensor

PCA9685 Adafruit's 16-channel 12-bit PWM/Servo Driver

5.5 mm Barrel Jack

4 LEDs

SPST Switch

100 Ohm Resistor 1W

150 Ohm Resistor 1W

1k Ohms Resistor 1/4 W

10K Resistor 1/4 W

1 Pair USB Powered Speakers

1 Dual 10K Potentiometer (logarithmic)

Electronics Build

GP LVL1 ELEPHANT 1 1 PINOUT.JPG

NOTE: GPIO conflict between GPIO18 and audio resulted in NEOPIXEL GPIO pin change from GPIO18 to GPIPO10. This change is not reflected in all illustrations and photos.

GP LVL1 ELEPHANT 1 0 WIRING.JPG

GP LVL1 ELEPHANT 1 0 PANEL LAYOUT.JPG

Actual Photos

Front of Assembly

GP LVL1 ELEPHANT PORTRAIT 1.jpg

Rear of Assembly

GP LVL1 ELEPHANT HEAD BACK 2.jpg

Back of Head

GP LVL1 ELEPHANT HEAD BACK 1.jpg

Electronics in Head

GP LVL1 ELEPHANT ELECTRONICS 1.jpg

Control Panel

GP LVL1 ELEPHANT CONTROL PANEL 1.jpg