Pseudo Medical Monitor Device 3D Print

Printed Parts

3D Printed Parts
Parts	ID	Purpose
	Control Panel Brackets	Fasten Control Panel to Main Device Sensor Layer Brackets are not symmetrical and are tailored for the Main Device Sensor Layer hole placement Screws shown with nuts provide offset positioning
	Port Mounting Brackets	Secure RJ45 Ports to Arduino DUE base layer of Main Device Brackets are not symmetrical and are tailored for the Arduino DUE hole placement Velco added post printing
	ATTiny85 Token Enclosure Box and Cover	Provides an enclosure for ATTiny85 Tokens
	Corner Bracket Set	Provides corner bracketing for EEG External Unit Threaded Inserts installed after printing
	Respiratory Sensor Signal Amplifier Box and Cover	Provides enclosure of PCB Access to adjustment potentiometer from cover

Assemblies With Printed Parts

Respiratory Sensor used with EKG External Unit

3D Printed Parts
	Two Compression Brackets IR Distance Compression Sensor Inside
	* BLUE - Compression Sensor Orientation Stabilizer * YELLOW - Compression Sensor Lower Bracket * GREEN - Compression Sensor Top Bracket * CYAN - Telescoping Tube Cradle * RED - Rubber Band (Provides Flexing of Compression Sensor Brackets) * VIOLET - Fastner (Holds Exterior Telescoping Tube Secure and Allows Inner Tube to Move) * SEMI-TRANSPARENT GREEN - Outer Telescoping Tube (Inner Telescoping Tube visible)

Respiratory Sensor used with Poly-Liar External Unit

• YELLOW - Telescoping Tube Cradle
• GREEN - Sliding Plunger
• RED - Rubber Band (Provides Resistance and Recoil for Sliding Plunger against Telescoping Cradle)
• VIOLET - Reflectance Sensor PCB
• BLUE - Fastner (Secures Slinging Plunger to Inner Telescoping Tube)
• ORANGE - Inner Telescoping Tube
• SEMI-TRANSPARENT BLUE - Guide Tube for Sliding Plunger
• SEMI-TRANSPARENT GREEN - Outer Telescoping Tube

Pseudo-Medical Monitor Device Design