Difference between revisions of "Wemos D1 Mini"

From LVL1
Jump to navigation Jump to search
Line 55: Line 55:
  
 
== OLED Shield ==
 
== OLED Shield ==
 +
* 64 X 48 pixels
 
* Product: https://wiki.wemos.cc/products:d1_mini_shields:oled_shield
 
* Product: https://wiki.wemos.cc/products:d1_mini_shields:oled_shield
 
* Code: https://github.com/mcauser/Adafruit_SSD1306/tree/esp8266-64x48
 
* Code: https://github.com/mcauser/Adafruit_SSD1306/tree/esp8266-64x48
 +
* in file Adafruit_SSD1306.h (arduino libraries) make sure to have the following:
 +
** #define SSD1306_I2C_ADDRESS  0x3C
 +
** #define SSD1306_64_48

Revision as of 21:40, 21 July 2017

These are instructions to get you going on a WeMos D1 Mini.

  • The Wemos D1 mini is a NodeMCU board made by wemos.cc
  • It is cheap <$5!
  • can be programmed using Arduino environment
  • can be loaded up with MicroPython <- tricky!
  • Wifi built in
  • 11 digital input/output pins, all pins have interrupt/pwm/I2C/one-wire supported(except D0)
  • 1 analog input(3.2V max input)
  • a Micro USB connection
  • Compatible with Arduino
  • Compatible with nodemcu
  • 4 Meg flash RAM


  • Loads of shields you can buy for it. https://wiki.wemos.cc/products:d1_mini_shields
    • DHT Shield
    • Battery Shield
    • Matrix LED Shield
    • Buzzer Shield
    • Dual Base
    • SHT30 Shield
    • WS2812B RGB Shield
    • ProtoBoard Shield
    • 1-Button Shield
    • Micro SD Card Shield
    • Relay Shield
    • DC Power Shield
    • Tripler Base
    • Motor Shield
    • OLED Shield

Setup

WIFI setup

SHT30 Shield

OLED Shield