Difference between revisions of "5th Inning"
Jump to navigation
Jump to search
(→How to) |
|||
| Line 20: | Line 20: | ||
==Schematic== | ==Schematic== | ||
| + | [[File:Lvl1-Inning5 schem.jpg]] | ||
==Fritzing== | ==Fritzing== | ||
Revision as of 22:00, 16 May 2010
Contents
Introduction
Pushbutton Switches
Components Needed
- Freeduino or Arduino or clone
- USB cable for Freeduino
- Freeduino development software - download here!
- Solderless Breadboard
- Hookup wire 22gauge solid
- Pushbutton Switch
- Soldering Iron and Solder to solder wires to switch
- 1 kOhm resistor (Brown-Black-Red)
How to
- For our workshop, you will have to solder some hookup wire to one of your pushbutton switches. Just strip back a half an inch of wire or so, stick it through the hole on the switch lead and solder. You will have help. It is easy.
- Follow the fritzing diagram and hook up the circuit.
- Cut and paste your code and run!
Schematic
