Clive Badger: Difference between revisions
Jump to navigation
Jump to search
Created page with "{{Template:Equipment|owner=LVL1 owned |model=Makerbot Replicator |serial=? |arrived=June 1, 2012 |doesitwork=Working |contact=Chris C |where=3D printing area in main room}}<br..." |
No edit summary |
||
| Line 7: | Line 7: | ||
|where=3D printing area in main room}}<br> | |where=3D printing area in main room}}<br> | ||
__NOTOC__ | __NOTOC__ | ||
==ReplicatorG default settings== | |||
* Slicing Profile: Replicator 2 Default | |||
* Use Raft / Support (Check if you have overhangs or many pieces on a single build, otherwise uncheck) | |||
* Use support Material (Exterior support if you have overhangs greater than 45 degree angles) | |||
* Use default start / end gcode (Always check) | |||
* Use Print-O-Matic (Always check) | |||
===Settings=== | |||
* Object Infill (10%) | |||
* Layer Height (.27) | |||
* Number of Shells (1) | |||
* Feedrate (41) | |||
* Travel Feedrate (51) | |||
* Print Temperature (220) | |||
Purchased for LVL1 from NSF funds for the UofL Speed School Co-op Makership | Purchased for LVL1 from NSF funds for the UofL Speed School Co-op Makership | ||
Revision as of 09:34, 10 December 2012
|
|
Equipment Overview
|
 |
ReplicatorG default settings
- Slicing Profile: Replicator 2 Default
- Use Raft / Support (Check if you have overhangs or many pieces on a single build, otherwise uncheck)
- Use support Material (Exterior support if you have overhangs greater than 45 degree angles)
- Use default start / end gcode (Always check)
- Use Print-O-Matic (Always check)
Settings
- Object Infill (10%)
- Layer Height (.27)
- Number of Shells (1)
- Feedrate (41)
- Travel Feedrate (51)
- Print Temperature (220)
Purchased for LVL1 from NSF funds for the UofL Speed School Co-op Makership