Pseudo Medical Monitor Device 3D Print: Difference between revisions
Jump to navigation
Jump to search
No edit summary |
No edit summary |
||
| Line 1: | Line 1: | ||
= Printed Parts = | |||
{|class="wikitable" | {|class="wikitable" | ||
!colspan="3"|3D Printed Parts | !colspan="3"|3D Printed Parts | ||
| Line 37: | Line 40: | ||
|} | |} | ||
= Assemblies With Printed Parts = | |||
== Respiratory Sensor used with EKG External Unit == | |||
== | |||
[[File:JAC MED MON RESP MODEL RENDER.jpg|left|thumbnail|x200px]] | [[File:JAC MED MON RESP MODEL RENDER.jpg|left|thumbnail|x200px]] | ||
| Line 54: | Line 57: | ||
* SEMI-TRANSPARENT GREEN - Outer Telescoping Tube (Inner Telescoping Tube visible) | * SEMI-TRANSPARENT GREEN - Outer Telescoping Tube (Inner Telescoping Tube visible) | ||
== | == Respiratory Sensor used with Poly-Liar External Unit == | ||
[[File:JAC MED MON RESP MODEL 2 RENDER C.jpg|left|thumbnail|x200px]] | [[File:JAC MED MON RESP MODEL 2 RENDER C.jpg|left|thumbnail|x200px]] | ||
Revision as of 16:28, 9 December 2021
Printed Parts
| 3D Printed Parts | ||
|---|---|---|
| Parts | ID | Purpose |
 |
Control Panel Brackets |
Fasten Control Panel to Main Device Sensor Layer Brackets are not symmetrical and are tailored for the Main Device Sensor Layer hole placement Screws shown with nuts provide offset positioning |
 |
Port Mounting Brackets |
Secure RJ45 Ports to Arduino DUE base layer of Main Device Brackets are not symmetrical and are tailored for the Arduino DUE hole placement Velco added post printing |
 |
ATTiny85 Token Enclosure Box and Cover | Provides an enclosure for ATTiny85 Tokens |
 |
Corner Bracket Set |
Provides corner bracketing for EEG External Unit Threaded Inserts installed after printing |
 |
Respiratory Sensor Signal Amplifier Box and Cover |
Provides enclosure of PCB Access to adjustment potentiometer from cover |
Assemblies With Printed Parts
Respiratory Sensor used with EKG External Unit
- BLUE - Compression Sensor Orientation Stabilizer
- YELLOW - Compression Sensor Lower Bracket
- GREEN - Compression Sensor Top Bracket
- CYAN - Telescoping Tube Cradle
- RED - Rubber Band (Provides Flexing of Compression Sensor Brackets)
- VIOLET - Fastner (Holds Exterior Telescoping Tube Secure and Allows Inner Tube to Move)
- SEMI-TRANSPARENT GREEN - Outer Telescoping Tube (Inner Telescoping Tube visible)
Respiratory Sensor used with Poly-Liar External Unit
- YELLOW - Telescoping Tube Cradle
- GREEN - Sliding Plunger
- RED - Rubber Band (Provides Resistance and Recoil for Sliding Plunger against Telescoping Cradle)
- VIOLET - Reflectance Sensor PCB
- BLUE - Fastner (Secures Slinging Plunger to Inner Telescoping Tube)
- ORANGE - Inner Telescoping Tube
- SEMI-TRANSPARENT BLUE - Guide Tube for Sliding Plunger
- SEMI-TRANSPARENT GREEN - Outer Telescoping Tube
