Group Project ELEPHANT 1.0: Difference between revisions
Jump to navigation
Jump to search
| Line 56: | Line 56: | ||
[[File:GP_LVL1_ELEPHANT_1_1_WIRING.JPG]] | [[File:GP_LVL1_ELEPHANT_1_1_WIRING.JPG]] | ||
'''NOTE:''' NEOPIXEL GPIO changed from 18 to 10. Previous wire X'ed out in RED. | |||
[[File:GP_LVL1_ELEPHANT_1_0_PANEL_LAYOUT.JPG]] | [[File:GP_LVL1_ELEPHANT_1_0_PANEL_LAYOUT.JPG]] | ||
Revision as of 11:29, 4 January 2020
Information
Structure Parts List
Table Leg
Wooden Bowl
Broken Wooden Bowl
2 U-Bolts and nuts
Wooden Panel Board Scrap
Chain
Electronics Parts List
Raspberry PI B
4 Relay Module
NeoPixel Strip
PIR Motion Sensor
PCA9685 Adafruit's 16-channel 12-bit PWM/Servo Driver
5.5 mm Barrel Jack
4 LEDs
SPST Switch
100 Ohm Resistor 1W
150 Ohm Resistor 1W
1k Ohms Resistor 1/4 W
10K Resistor 1/4 W
1 Pair USB Powered Speakers
1 Dual 10K Potentiometer (logarithmic)
Electronics Build
NOTE: GPIO conflict between GPIO18 and audio resulted in NEOPIXEL GPIO pin change from GPIO18 to GPIO10. This change is not reflected in all illustrations and photos.
NOTE: NEOPIXEL GPIO changed from 18 to 10. Previous wire X'ed out in RED.
Actual Photos
Front of Assembly
Rear of Assembly
Back of Head
Electronics in Head
Control Panel
