Difference between revisions of "Group Project ELEPHANT 1.0"
Jump to navigation
Jump to search
Line 53: | Line 53: | ||
[[File:GP_LVL1_ELEPHANT_1_1_PINOUT.JPG]] | [[File:GP_LVL1_ELEPHANT_1_1_PINOUT.JPG]] | ||
− | + | '''NOTE:''' GPIO conflict between GPIO18 and audio resulted in NEOPIXEL GPIO pin change from GPIO18 to GPIPO10. This change is not reflected in all illustrations and photos. | |
[[File:GP_LVL1_ELEPHANT_1_0_WIRING.JPG]] | [[File:GP_LVL1_ELEPHANT_1_0_WIRING.JPG]] |
Revision as of 12:17, 4 January 2020
Contents
Information
Structure Parts List
Table Leg
Wooden Bowl
Broken Wooden Bowl
2 U-Bolts and nuts
Wooden Panel Board Scrap
Chain
Electronics Parts List
Raspberry PI B
4 Relay Module
NeoPixel Strip
PIR Motion Sensor
PCA9685 Adafruit's 16-channel 12-bit PWM/Servo Driver
5.5 mm Barrel Jack
4 LEDs
SPST Switch
100 Ohm Resistor 1W
150 Ohm Resistor 1W
1k Ohms Resistor 1/4 W
10K Resistor 1/4 W
1 Pair USB Powered Speakers
1 Dual 10K Potentiometer (logarithmic)
Electronics Build
NOTE: GPIO conflict between GPIO18 and audio resulted in NEOPIXEL GPIO pin change from GPIO18 to GPIPO10. This change is not reflected in all illustrations and photos.