Difference between revisions of "Crealities"
Jump to navigation
Jump to search
| (One intermediate revision by the same user not shown) | |||
| Line 1: | Line 1: | ||
{{Template:Equipment | {{Template:Equipment | ||
| − | |owner= | + | |owner=LVL1 |
| − | |serial= | + | |serial= |
| − | |model=Ender 3 | + | |model=Creality Ender 3. |
| − | |arrived=1/ | + | |arrived=1/1/24 |
| − | |doesitwork= | + | |doesitwork=Yes |
| − | |where= | + | |contact=Matt, Paul, and Kevin |
| + | |where=3d Printers | ||
|picture=wiki URL | |picture=wiki URL | ||
}} | }} | ||
| + | |||
| + | =Creality Ender 3s= | ||
| + | <big>Do not adjust the bed screws</big> | ||
| + | |||
| + | LVL1 Has three Creality Ender 3s. They are configured to use a manual mesh. Your slicer must insert the gcode: | ||
| + | |||
| + | *M420 S1 | ||
| + | |||
| + | |||
| + | In the header. The Ender-3 profile on the 3d printing computer already has this set up. | ||
| + | |||
Page for Creality Equipment | Page for Creality Equipment | ||
Latest revision as of 22:19, 1 April 2024
[Equipment|Back to list of Equipment]]
|
|
General
|
Creality Ender 3s
Do not adjust the bed screws
LVL1 Has three Creality Ender 3s. They are configured to use a manual mesh. Your slicer must insert the gcode:
- M420 S1
In the header. The Ender-3 profile on the 3d printing computer already has this set up.
Page for Creality Equipment
