Difference between revisions of "Pseudo Medical Monitor Device 3D Print"

Revision as of 16:24, 9 December 2021

3D Printed Parts
Parts	ID	Purpose
	Control Panel Brackets	Fasten Control Panel to Main Device Sensor Layer Brackets are not symmetrical and are tailored for the Main Device Sensor Layer hole placement Screws shown with nuts provide offset positioning
	Port Mounting Brackets	Secure RJ45 Ports to Arduino DUE base layer of Main Device Brackets are not symmetrical and are tailored for the Arduino DUE hole placement Velco added post printing
	ATTiny85 Token Enclosure Box and Cover	Provides an enclosure for ATTiny85 Tokens
	Corner Bracket Set	Provides corner bracketing for EEG External Unit Threaded Inserts installed after printing
	Respiratory Sensor Signal Amplifier Box and Cover	Provides enclosure of PCB Access to adjustment potentiometer from cover

BLUE - Compression Sensor Orientation Stabilizer
YELLOW - Compression Sensor Lower Bracket
GREEN - Compression Sensor Top Bracket
CYAN - Telescoping Tube Cradle
RED - Rubber Band (Provides Flexing of Compression Sensor Brackets)
VIOLET - Fastner (Holds Exterior Telescoping Tube Secure and Allows Inner Tube to Move)
SEMI-TRANSPARENT GREEN - Outer Telescoping Tube (Inner Telescoping Tube visible)

YELLOW - Telescoping Tube Cradle
GREEN - Sliding Plunger
RED - Rubber Band (Provides Resistance and Recoil for Sliding Plunger against Telescoping Cradle)
VIOLET - Reflectance Sensor PCB
BLUE - Fastner (Secures Slinging Plunger to Inner Telescoping Tube)
ORANGE - Inner Telescoping Tube
SEMI-TRANSPARENT BLUE - Guide Tube for Sliding Plunger
SEMI-TRANSPARENT GREEN - Outer Telescoping Tube

@@ Line 32: / Line 32: @@
 |[[File:JAC MED MON RESPIRATORY SENSOR BOX.jpg|thumb]]
 | Respiratory Sensor Signal Amplifier Box and Cover
-| Provides enclosure of PCB and access to adjustment potentiometer within
+|
+ Provides enclosure of PCB
+ Access to adjustment potentiometer from cover
 |}