Difference between revisions of "Pseudo Medical Monitor Device 3D Print"
Jump to navigation
Jump to search
| Line 10: | Line 10: | ||
| | | | ||
Fasten Control Panel to Main Device Sensor Layer | Fasten Control Panel to Main Device Sensor Layer | ||
| − | Brackets are not | + | Brackets are not symmetrical and are tailored for the Main Device Sensor Layer hole placement |
|- | |- | ||
|[[File:JAC_MED_MON_PORT_MOUNTING_BRACKETS.jpg|left|thumbnail|x200px]] | |[[File:JAC_MED_MON_PORT_MOUNTING_BRACKETS.jpg|left|thumbnail|x200px]] | ||
| Line 16: | Line 16: | ||
| | | | ||
Secure RJ45 Ports to Arduino DUE base layer of Main Device | Secure RJ45 Ports to Arduino DUE base layer of Main Device | ||
| + | Brackets are not symmetrical and are tailored for the Arduino DUE hole placement | ||
Velco added post printing | Velco added post printing | ||
|- | |- | ||
Revision as of 16:21, 9 December 2021
| 3D Printed Parts | ||
|---|---|---|
| Parts | ID | Purpose |
| Control Panel Brackets |
Fasten Control Panel to Main Device Sensor Layer Brackets are not symmetrical and are tailored for the Main Device Sensor Layer hole placement | |
| Port Mounting Brackets |
Secure RJ45 Ports to Arduino DUE base layer of Main Device Brackets are not symmetrical and are tailored for the Arduino DUE hole placement Velco added post printing | |
| ATTiny85 Token Enclosure Box and Cover | Provides an enclosure for ATTiny85 Tokens | |
| Corner Bracket Set |
Provides corner bracketing for EEG External Unit Threaded Inserts installed after printing | |
| Respiratory Sensor Signal Amplifier Box and Cover | Provides enclosure of PCB and access to adjustment potentiometer within | |
Respitory Sensor Model A
- BLUE - Compression Sensor Orientation Stabilizer
- YELLOW - Compression Sensor Lower Bracket
- GREEN - Compression Sensor Top Bracket
- CYAN - Telescoping Tube Cradle
- RED - Rubber Band (Provides Flexing of Compression Sensor Brackets)
- VIOLET - Fastner (Holds Exterior Telescoping Tube Secure and Allows Inner Tube to Move)
- SEMI-TRANSPARENT GREEN - Outer Telescoping Tube (Inner Telescoping Tube visible)
Respitory Sensor Model B
- YELLOW - Telescoping Tube Cradle
- GREEN - Sliding Plunger
- RED - Rubber Band (Provides Resistance and Recoil for Sliding Plunger against Telescoping Cradle)
- VIOLET - Reflectance Sensor PCB
- BLUE - Fastner (Secures Slinging Plunger to Inner Telescoping Tube)
- ORANGE - Inner Telescoping Tube
- SEMI-TRANSPARENT BLUE - Guide Tube for Sliding Plunger
- SEMI-TRANSPARENT GREEN - Outer Telescoping Tube
