Difference between revisions of "Pseudo Medical Monitor Device 3D Print"
Jump to navigation
Jump to search
| Line 21: | Line 21: | ||
| Corner Bracket Set | | Corner Bracket Set | ||
| Provides corner bracketing for EEG External Unit | | Provides corner bracketing for EEG External Unit | ||
| + | Threaded Inserts installed after printing | ||
|- | |- | ||
|[[File:JAC MED MON RESPIRATORY SENSOR BOX.jpg|thumb]] | |[[File:JAC MED MON RESPIRATORY SENSOR BOX.jpg|thumb]] | ||
Revision as of 16:16, 9 December 2021
| 3D Printed Parts | ||
|---|---|---|
| Parts | ID | Purpose |
| Control Panel Brackets | Fasten Control Panel to Main Device Sensor Layer | |
| Port Mounting Brackets | Secure RJ45 Ports to Arduino DUE base layer of Main Device. | |
| ATTiny85 Token Enclosure Box and Cover | Provides an enclosure for ATTiny85 Tokens | |
| Corner Bracket Set | Provides corner bracketing for EEG External Unit
Threaded Inserts installed after printing | |
| Respiratory Sensor Signal Amplifier Box and Cover | Provides enclosure of PCB and access to adjustment potentiometer within | |
Respitory Sensor Model A
- BLUE - Compression Sensor Orientation Stabilizer
- YELLOW - Compression Sensor Lower Bracket
- GREEN - Compression Sensor Top Bracket
- CYAN - Telescoping Tube Cradle
- RED - Rubber Band (Provides Flexing of Compression Sensor Brackets)
- VIOLET - Fastner (Holds Exterior Telescoping Tube Secure and Allows Inner Tube to Move)
- SEMI-TRANSPARENT GREEN - Outer Telescoping Tube (Inner Telescoping Tube visible)
Respitory Sensor Model B
- YELLOW - Telescoping Tube Cradle
- GREEN - Sliding Plunger
- RED - Rubber Band (Provides Resistance and Recoil for Sliding Plunger against Telescoping Cradle)
- VIOLET - Reflectance Sensor PCB
- BLUE - Fastner (Secures Slinging Plunger to Inner Telescoping Tube)
- ORANGE - Inner Telescoping Tube
- SEMI-TRANSPARENT BLUE - Guide Tube for Sliding Plunger
- SEMI-TRANSPARENT GREEN - Outer Telescoping Tube
