Difference between revisions of "Drill Press - Buffalo Forge Number 15"
Jump to navigation
Jump to search
| Line 40: | Line 40: | ||
Here is a link for the manual: | Here is a link for the manual: | ||
| − | * https://drive.google.com/file/d/ | + | * https://drive.google.com/file/d/1EK5MmMQB_wEcPeUIU3VVBhkvWqe3Nyj8/view?usp=sharing |
Revision as of 17:26, 16 July 2020
[Equipment|Back to list of Equipment]]
|
|
General
|
 |
Usage/Safety
General safety instructions for power tools (from this machine's manual)
- 01. Know your power tool (read and understand the owner's manual before using and understand the specific hazards)
- 02. Ground all tools (use grounded 3-prong plug inserted into proper grounding type receptacle)
- 03. Keep guards in place (and in working order with proper adjustment and alignment)
- 04. Remove adjusting keys and wrenches (form habit to check they are removed from tool before turning on the machine)
- 05. Keep work area clean (cluttered areas and benches invite accidents and floor may be slippery due to sawdust)
- 06. Avoid dangerous environment (don't use power tools in damp or wet locations, keep work area well lighted)
- 07. Keep children away (all visitors should be kept at a safe distance)
- 08. Make workshop kid-proof (consider padlocks, master switches and/or starter keys)
- 09. Dont force tool (it will do the job better and safer at the rate for which it was designed)
- 10. Use right tool (don't force the tool or attachment to do a job it was not designed for)
- 11. Wear proper apparel (don't wear loose clothing, gloves, neckties, or jewelry, contain long hair, roll-up sleeves above the elbow)
- 12. Use safety goggles (must comply with ANSI Z87.1, use face or dust mask and ear protection during extended periods of usage)
- 13. Secure work (use clamps or a vice to hold work when practical as it is safer than using your hand)
- 14. Don't overreach (keep proper footing and balance at all times)
- 15. Maintain tools with care (keep tools sharp and clean for best and safest performance)
- 16. Disconnect tools (before servicing when changing accessories, belts, and disks)
- 17. Avoid accidental starting (make sure switch in in "OFF" position before plugging in)
- 18. Use recommended accessories (consult the manual for recommended accessories, follow instructions, improper accessories may cause hazards)
- 19. Never stand on tool (seriousl injury could occur if the tool is tipped or if the cutting tool is accidentally contacted)
- 20. Check damaged parts (a damaged guard should be checked for proper function, check alignment of moving parts, binding, breakage, etc.)
- 21. Direction of feed (feed work into a blade or cutter against the direction of rotation of the blade or cutter only)
- 22. Never leave tool running unattended (turn power off and don't leave the tool until it comes to a complete stop)
Watch this good generic introduction safety usage YouTube video (12:27 mm:ss) and/or find additional similar videos
Here is a link for the manual:
