Robo-Pony

From LVL1
Revision as of 13:46, 5 July 2015 by Notyou007a (talk | contribs)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigation Jump to search

Back to list of Equipment

Lvl1 qr header.png
Robo-Pony&.png

General

LVL1 has three Ender 3 printers available for general use.

  • Owner/Loaner: LVL1
  • Serial Number: MISC
  • Make/Model: Standard/Pro
  • Arrival Date: 1/12/24
  • Usability: Yes
  • Contact: Matt, Kevin, Paul
  • Where: 3D Printing
Ender 3 Printers


Firmware

Matt has compiled a firmware for our Ender 3s:

One drive link to .bin files

Mapping

Moters

Color Lable Part Bi-Derectional Voltage
Purple M3+ Head Turn Yes 5V
Brown M3- Head Turn Yes Ground
Green M4+ Tail No 5V
Yellow M4- Tail No Ground
Blue M5+ Head nod no 5V
Purple M5- Head nod No Ground

Sensors

Label= Wiper3 Connecter color= Black

Pin Wire color Reads Notes
1 Blue Head Turn angle Common Ground
2 Gray Head Turned Left Switch is off when turned to the left
3 Gray Head Turned Right Switch is off when turned to the Right
4 Gray Head Middle Switches off when in the middle

over laps with left and right switch

switches Tail, Label=tailsw, two wire, Yellow Connecter, Closed? when tail in center down
Butt switch, Label=Rider, Two wire, Green Connecter, open?when down
Head Left and Right?, Label=Wiper 4, 4 wire, white connecter, One Blue + 3 Gray.

Input
MIC2(L) White 2 pin
MIC1(R) Black 2 pin

Output
SPK2 Purple


Don't know
CS 3,4,1 (Capacitive sensor?)
Gray = Front Left
Blue = Back Left
Red = Back Right

CS 2,5 (cap)
Yellow = Front Right
Red = Front Center