KeyLessEntry

From LVL1
Revision as of 23:15, 18 June 2015 by Notyou007a (talk | contribs)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigation Jump to search

NOTE this information was applicable in the old space; after LVL1 moved to The Pointe, at 1205 E. Washington St., this system is no longer established.

Back to list of Equipment

Lvl1 qr header.png
KeyLessEntry&.png

General

LVL1 has three Ender 3 printers available for general use.

  • Owner/Loaner: LVL1
  • Serial Number: MISC
  • Make/Model: Standard/Pro
  • Arrival Date: 1/12/24
  • Usability: Yes
  • Contact: Matt, Kevin, Paul
  • Where: 3D Printing
Ender 3 Printers


Firmware

Matt has compiled a firmware for our Ender 3s:

One drive link to .bin files

How To Use

  • To Unlock the door
    • Place badge near reader until 3 beeps are heard
    • Enter your 4 digit pin followed by the # key
    • You should hear the door unlatch
  • To Unlock the Door for X hours
    • Place badge near reader until 3 beeps are heard
    • Enter your 4 digit pin followed by the # key
    • Press 1 followed by the # key
    • Enter X (number of hours) followed by the # key
      • Note you can only unlock the door for up to 8 hours
  • To Lock the Door
    • Place badge near reader until 3 beeps are heard
    • Enter your 4 digit pin followed by the # key
    • Press 2 followed by the # key
    • You will hear the system beep once a second for about 10 secs then lock
  • To Toggle the State of the Garage Door
    • Place badge near reader until 3 beeps are heard
    • Enter your 4 digit pin followed by the # key
    • Press 3 followed by the # key
    • The garage door will then change state (e.g. If open then will close)