Difference between revisions of "2nd Inning"

From LVL1
Jump to navigation Jump to search
Line 20: Line 20:
  
 
==Code==
 
==Code==
{
+
<pre>
  
 
/*
 
/*
Line 63: Line 63:
 
}
 
}
  
}
+
</pre>
  
 
==Troubleshooting==
 
==Troubleshooting==

Revision as of 11:25, 13 May 2010

Introduction

Blinking LED


Components Needed

  • Freeduino or Arduino or clone
  • USB cable for Freeduino
  • Freeduino development software - download here!
  • Solderless Breadboard
  • Hookup wire 22gauge solid

How to

Schematic

Lvl1-Inning2 schem.jpg

Fritzing

Lvl1-Inning2 bb.jpg

Code


/*
  Blink
 
 Turns on an LED on for one second, then off for one second, repeatedly.
 
 The circuit:
 * LED connected from digital pin 13 to ground.
 
 * Note: On most Arduino boards, there is already an LED on the board
 connected to pin 13, so you don't need any extra components for this example.
 
 
 Created 1 June 2005
 By David Cuartielles
 
 http://arduino.cc/en/Tutorial/Blink
 
 based on an orginal by H. Barragan for the Wiring i/o board
 
 */

int ledPin =  13;    // LED connected to digital pin 13

// The setup() method runs once, when the sketch starts

void setup()   {                
  // initialize the digital pin as an output:
  pinMode(ledPin, OUTPUT);     
}

// the loop() method runs over and over again,
// as long as the Arduino has power

void loop()                     
{
  digitalWrite(ledPin, HIGH);   // set the LED on
  delay(1000);                  // wait for a second
  digitalWrite(ledPin, LOW);    // set the LED off
  delay(1000);                  // wait for a second
}

Troubleshooting