Difference between revisions of "ShopBot"
Jump to navigation
Jump to search
m |
|||
| (3 intermediate revisions by 2 users not shown) | |||
| Line 7: | Line 7: | ||
|contact=Daniel Johnsen | |contact=Daniel Johnsen | ||
|where=Woodshop | |where=Woodshop | ||
| − | |picture= | + | |picture=DSC 7286.JPG |
}} | }} | ||
| Line 13: | Line 13: | ||
Trainers | Trainers | ||
| − | Daniel Johnsen, Micah "Meesh" Burkhardt, | + | Daniel Johnsen, Micah "Meesh" Burkhardt, Brian Wagner |
Trained Individuals | Trained Individuals | ||
| Line 19: | Line 19: | ||
== Instructions and How To == | == Instructions and How To == | ||
How to cut aluminum sheets [[Cutting_Aluminum_Sheet_On_Shopbot]] | How to cut aluminum sheets [[Cutting_Aluminum_Sheet_On_Shopbot]] | ||
| + | |||
| + | ---- | ||
| + | |||
| + | X and Y limit switches for the shopbot are | ||
| + | |||
| + | Baumer Inductive sensor | ||
| + | IFRM 08N37A3/S35L . DataSheet: [https://www.baumer.com/asset/medias/__secure__/IFRM_08N37A3_S35L_web_EN.pdf?mediaPK=8799281545246] | ||
| + | |||
| + | Y Limit Switch replaced 5/7/19 by B Wagner | ||
| + | Sensor purchased on ebay for about $50 | ||
| + | |||
| + | |||
| + | ---- | ||
Latest revision as of 17:26, 4 January 2023
[Equipment|Back to list of Equipment]]
|
|
General
|
 |
Note: Training & sign-off is required to use this machine. This is an advanced piece of equipment that can cause harm to itself, the surroundings, users and bystanders. Do not hack this machine.
Trainers Daniel Johnsen, Micah "Meesh" Burkhardt, Brian Wagner
Trained Individuals
Instructions and How To
How to cut aluminum sheets Cutting_Aluminum_Sheet_On_Shopbot
X and Y limit switches for the shopbot are
Baumer Inductive sensor IFRM 08N37A3/S35L . DataSheet: [1]
Y Limit Switch replaced 5/7/19 by B Wagner Sensor purchased on ebay for about $50
