Difference between revisions of "Network"

Revision as of 23:17, 23 August 2014

Network

We have standards now! Please do not add hodgepodge stuff to our network infrastructure. Please see parts list below.
There are two subnets, 10.0.0.0/23 for wired clients and 10.0.2.0/24 for wireless. The DHCP pool takes exactly 10.0.1.0/24
What this means in laymans terms:
- Any IP that starts with 10.0.0 is a static IP
- Any IP that starts with 10.0.1 is a dynamic wired IP
- Any IP that starts with 10.0.2 is a dynamic wireless client
The wireless access point comes directly off the pfSense box and does not pass through the switches in the rack. This just eliminates a few points of failure.
Spanning tree is enabled (with portfast) and bpdu guard. If you create a loop the ports will get disabled. Telnet into the appropriate switch to re-enable it. All ports are labeled.
- For example: A7 = port 7 on switch A. If it is disabled:

telnet switch-a.lvl1.lan
conf t
int 7
enable

Internet Service graciously provided by http://bluegrass.net

Wired: 10.0.0.0/23
- DHCP Pool: 10.0.1.0/24
- all static IPs should be between 10.0.0.1 and 10.0.0.255
Wireless: 10.0.2.0/24

@@ Line 11: / Line 11: @@
 ** Any IP that starts with 10.0.1 is a dynamic wired IP
 ** Any IP that starts with 10.0.2 is a dynamic wireless client
+* The wireless access point comes directly off the pfSense box and does not pass through the switches in the rack.  This just eliminates a few points of failure.
+* Spanning tree is enabled (with portfast) and bpdu guard.  If you create a loop the ports will get disabled.  Telnet into the appropriate switch to re-enable it.  All ports are labeled.
+** For example: A7 = port 7 on switch A.  If it is disabled:
+<pre>telnet switch-a.lvl1.lan
+conf t
+int 7
+enable</pre>
 '''Internet Service graciously provided by http://bluegrass.net'''