Difference between revisions of "Arduino 101"
Jump to navigation
Jump to search
Line 1: | Line 1: | ||
= Project 1 = | = Project 1 = | ||
− | + | { | |
int potInputPin = 0; | int potInputPin = 0; | ||
int servoOutputPin = 11; | int servoOutputPin = 11; | ||
Line 10: | Line 10: | ||
void setup() | void setup() | ||
− | + | { | |
pinMode(servoOutputPin, OUTPUT); | pinMode(servoOutputPin, OUTPUT); | ||
pinMode(smallAngleLEDPin, OUTPUT); | pinMode(smallAngleLEDPin, OUTPUT); | ||
Line 16: | Line 16: | ||
analogWrite(servoOutputPin, analogValue); | analogWrite(servoOutputPin, analogValue); | ||
Serial.begin(9600); | Serial.begin(9600); | ||
− | + | } | |
void loop() | void loop() | ||
Line 41: | Line 41: | ||
delay(100); | delay(100); | ||
} | } | ||
− | + | } |
Revision as of 00:27, 7 November 2015
Project 1
{ int potInputPin = 0; int servoOutputPin = 11; int smallAngleLEDPin = 2; int largeAngleLEDPin = 4; int minValue = 64; int maxValue = 192; int analogValue = 512;
void setup() {
pinMode(servoOutputPin, OUTPUT); pinMode(smallAngleLEDPin, OUTPUT); pinMode(largeAngleLEDPin, OUTPUT); analogWrite(servoOutputPin, analogValue); Serial.begin(9600);
}
void loop() {
analogValue = analogRead(potInputPin); Serial.println(analogValue); analogValue = analogValue / 4; Serial.println(analogValue);
if (analogValue < minValue) { digitalWrite(smallAngleLEDPin, HIGH); } else if (analogValue > maxValue) { digitalWrite(largeAngleLEDPin, HIGH); } else { digitalWrite(smallAngleLEDPin, LOW); digitalWrite(largeAngleLEDPin, LOW); analogWrite(servoOutputPin, analogValue); } delay(100);
} }