Difference between revisions of "2019 Shapeoko 2 Refurbishment"
Jump to navigation
Jump to search
Line 75: | Line 75: | ||
The circuitry on the Prototyping Shield added noise filtering and debounce protection to the Limit Switch Lines and Control Buttons on the E-Stop pendant. | The circuitry on the Prototyping Shield added noise filtering and debounce protection to the Limit Switch Lines and Control Buttons on the E-Stop pendant. | ||
− | The circuitry in the photo was modified according to | + | The circuitry in the photo was modified according to the schematic below to improve debounce behavior. |
[[File:General_Shapeoko_Switch_Pin_Filter.jpg]] | [[File:General_Shapeoko_Switch_Pin_Filter.jpg]] |
Revision as of 23:30, 19 June 2019
Contents
- 1 General Information
- 1.1 Goal 1: Shapeoko 2 Device Refurbishment
- 1.2 Goal 1: Placement of Custom 3D Printed Parts
- 1.3 Goal 1: Rewiring
- 1.4 Goal 1: Completion
- 1.5 Goal 2: Controller System
- 1.6 Goal 2: Controller Description
- 1.7 Goal 2: Controller Box
- 1.8 Goal 2: Front Panel Build
- 1.9 Goal 2: Rear Panel Build
- 1.10 Goal 2: Electronics
- 2 General Photos
General Information
Goal 1: Shapeoko 2 Device Refurbishment
Goal 1: Placement of Custom 3D Printed Parts
Goal 1: Rewiring
Goal 1: Completion
Goal 2: Controller System
Goal 2: Controller Description
Goal 2: Controller Box
Controller Box Assembled
Controller Box Disassembled
Goal 2: Front Panel Build
Goal 2: Rear Panel Build
Goal 2: Electronics
Three Boards - Arduino Uno, Arduino Prototyping Shield, CNC Shield V3.0
The circuitry on the Prototyping Shield added noise filtering and debounce protection to the Limit Switch Lines and Control Buttons on the E-Stop pendant. The circuitry in the photo was modified according to the schematic below to improve debounce behavior.
Controller Box 3D Printed Items
General Photos
E-Stop Pendant
E-Stop Pendant Power Cutoff Wiring
Power Box
Controller Box
Controller Panels
Electronics
GRBL Controller
General Layout