Murphy
[Equipment|Back to list of Equipment]]
Contents
General
|
General Info
Murphy is a franken-taz that has been upgraded piece by piece from a stock taz-3. It currently has the Taz 5 hexagon v2 hotend with .5mm nozzle attached. Murphy can handle a variety of materials, but is configured by default for PLA. Murphy requires 3mm filament. Murphy can print from SD card or the Ubuntu workstation to the left.
Because it is not stock, some settings in the firmware are custom. Please exercise caution (or refrain from) when uploading firmware.
Getting Started
Cura
Launch Cura by clicking it's icon in the quick launcher
Print Profiles
The TAZ can print a variety of materials, but the two most common are PLA and ABS. PLA is much easier to work with, while ABS is sturdier and more resistant to heat. Murphy is configured to print PLA by default. For printing purposes, PLA uses a lower bed and extruder temperature. Spools should be labeled, but the following video can help you identify unlabeled filament.
Pre-Print
There are several steps
Software
1. Load Model 2. Arrange Model 3. Verify Settings 4. Launch Control Panel
Physical Equipment
5. Load Filament 6. Verify Idler Tension 7. Level the Bed
Watch first layer.
Trouble Shooting
It Jammed
Clean Hobbed Bolt
Check Fans
Machine Calibration