Difference between revisions of "LazerTazerTag"
Jump to navigation
Jump to search
Line 45: | Line 45: | ||
* IR Med Packs | * IR Med Packs | ||
* IR Granades | * IR Granades | ||
+ | |||
+ | == Build Instructions for Full Set == | ||
+ | |||
+ | === Gun Wiring === | ||
+ | Gun wiring taps inside gun and comes out through headphone port. Terminate each end with a JST plug and label as 1,2,3. | ||
+ | |||
+ | * IR Receiver | ||
+ | * 5V | ||
+ | * Gnd | ||
+ | * On/Off Toggle | ||
+ | * LifeLED1 | ||
+ | * LifeLED2 | ||
+ | * LifeLED3 | ||
+ | * TeamSelect | ||
+ | * IR Out | ||
+ | |||
+ | === IR Domes === | ||
+ | IR Domes get wired to a JST plug | ||
+ | |||
+ | * IR Recieve | ||
+ | * Pwr | ||
+ | * Gnd | ||
+ | |||
+ | === Tense Leads === | ||
+ | Tens leads are left as Raw leads and ran through the shoulder and belt loops to the inside of the vest pocket. | ||
+ | |||
+ | * GND lead of each tense set goes to common groun | ||
+ | * V+ of each lead gets ran through 5V relay channel |
Revision as of 12:27, 23 July 2012
Contents
Still To Figure Out
- Sending Medic IR from arduino
- SpreadSheet of all IR Codes [1]
- Reading IR pin on Arduino
- SpreadSheet of all IR Codes [2]
- Setup Game Sketch in Arduino
- Would be nice to figure out how to use a small chip to just out a specific IR code over and over
Task To Do
- Build Cardboard Forts and Barriers
- Make additional 360 IR Domes
- Make 2 more full arm/leg band sets
- Move guns On/Off switch to arduino pin
- Move guns "Team Select button to Arduino Pin
- Add 2 Arduino ON/Off Push Buttons for gameplay options
Need To Purchase or Acquire
- More IR Receivers
- Possibly More Tense Units
- IR Domes and PCB's
- Possibly Two more Rifles
- LOTS OF BATTERIES
- Two more packs of elastic for arm/leg bands
- Facemask
- Knee Pads
- Elbow Pads
Arduino GamePlay
The arduino will control the on/off of the gun. Game Play order:
- Gun On
- Finger Print on Rifles
- Set Team
- Check for Three Solid Life bars
- Start Game
- IR In is on interrupt
If we have time
- IR Blaster on Parrot AR Drone
- IR Med Packs
- IR Granades
Build Instructions for Full Set
Gun Wiring
Gun wiring taps inside gun and comes out through headphone port. Terminate each end with a JST plug and label as 1,2,3.
- IR Receiver
- 5V
- Gnd
- On/Off Toggle
- LifeLED1
- LifeLED2
- LifeLED3
- TeamSelect
- IR Out
IR Domes
IR Domes get wired to a JST plug
- IR Recieve
- Pwr
- Gnd
Tense Leads
Tens leads are left as Raw leads and ran through the shoulder and belt loops to the inside of the vest pocket.
- GND lead of each tense set goes to common groun
- V+ of each lead gets ran through 5V relay channel