Talk:Graphtec Vinyl Cutter

From LVL1
Jump to navigation Jump to search

This link:

If you run into a HPGL error on the cutter, then the cutter is in the wrong mode. Follow these instructions to put your cutter in the correct mode... http://www.signwarehouse.com/support/index.php?_m=knowledgebase&_a=viewarticle&kbarticleid=292

is no longer valid. I searched their knowledgebase and was unable to find the article or any others that seemed to fit using keywords HPGL error and cutter mode.

I have removed that bit from the page. Does anyone know what that article said so we can incorporate it into this wiki?